Skip to content
Making · 1 Mar 2021

First Watercooled Rig

My first PC build since 2010, in an Antec Striker, with a custom acrylic loop and a pump that didn't fit.

READ
3 min read
WORDS
488
BUILD
1 Mar 2021
pc buildwatercoolingmini itxantec striker
§ 01

Introduction

I hadn't built a PC since about 2010. I spotted the Antec Striker case a couple of times and had to build one. I went way over budget, but I'm happy with how it turned out.

The finished build on a wooden crate in front of a window with plants

§ 02

Parts

All the parts laid out on a desk before the build

PartSelection
CPUAMD Ryzen 7 5800X
MotherboardGigabyte X570 I Aorus Pro WiFi (Mini ITX, AM4)
MemoryG.Skill Ripjaws V 32 GB (2 x 16 GB) DDR4-3600 CL16
StorageGigabyte Aorus Gen4 1 TB NVMe
GPUMSI GeForce RTX 3070 Suprim 8G
CaseAntec Striker Mini ITX
PSUAsus ROG Strix 750 W 80+ Gold, fully modular
Fans2 x EK Vardar X3M 120 mm
MonitorGigabyte G32QC 31.5" 2560 x 1440 165 Hz curved
OSWindows 10 Home

The loop

You can't really pick watercooling parts on PCPartPicker, so here they are separately.

PartSelection
PumpEK-Quantum Inertia D5 PWM D-RGB
ReservoirBarrow Boxfish, 250 mm
CPU blockPhanteks Glacier C350a
Radiator, fittings, filterBykski
Tubing14 mm acrylic
§ 03

Making it fit

The Striker with the GPU mounted vertically at the front and the loop lit teal

PCPartPicker warned me the GPU was too long for the case. It sits vertically at the front, so I ignored the warning and figured I'd make it work. It fits fine.

The EK D5 pump was far bigger than I expected. Mounted where I'd planned, it would have stopped the glass going back on the case. So I drilled mounting holes in one of the Striker's inner plates and mounted the reservoir and pump back to back on it.

I picked the Barrow reservoir because its measurements looked like they'd fit the space nicely. The 14 mm acrylic was arbitrary: I'd happily have used 12 or 16. I chose acrylic because it looked like it would be the clearest and nicest, and because I like a challenge. It worked out well, but it is a pain to cut.

Hand-cut acrylic tubing running past the motherboard

The EK D5 pump and two Vardar fans, lit teal

A lucky cat figure tucked in beside the GPU

§ 04

What's next

There's no water block for this GPU yet. When there is, I'll extend the loop to cool it too. The pump is overkill for the current setup, but it'll be right for a second radiator and block. I haven't gamed on it much, but it's handled everything I've thrown at it so far.

END OF ENTRY